Manual cleaning and degreasing
We manually clean and degrease workpieces before further treatment.
A clean basis for further treatment
After internal transport, manual cleaning and degreasing may be required before a workpiece receives further treatment. This prevents existing contamination from being carried into the next process step.
Areas that must not be treated can then be masked or plugged. Inspection arrangements are explained on our quality page.
Process
From assessment to the next step
The work is matched to the component and the agreed subsequent treatment.
-
Assessment
We consider the workpiece and the treatment that will follow.
-
Cleaning and degreasing
The workpiece is manually cleaned and degreased in preparation for further treatment.
-
Further preparation
Where required, areas that must not be treated are masked or plugged.
Next step
Prepared for blasting or coating
Manual cleaning and degreasing is a preparatory step for treatments including abrasive blasting and wet paint coating.
We agree the required process steps with you for each workpiece and order.
Preparing a workpiece for treatment?
Contact us to discuss cleaning, degreasing and the subsequent process steps.
